We havent installed ours yet, but are looking at the.
It worked like a charm.
The track is now finished, in the sense that you can run cars on it, but to really race, a lap counter/timing system is needed.
Bottom line: Sectional track is much higher in maintenance than any wood track.We think this is large enough for a home track, considering the short lengths of the wire runs the relatively low-amp motors we will be running.All wire, except for the power supply leads to the terminal strip, is 14AWG.Again, youll learn by doing, but its always a good idea to practice anything unfamiliar table mountain casino roulette first on mockups of the real thing.Next is the copper tape.Each control panel was made up from a piece of hardwood plywood for a base, with a piece of MDF glued into a dado cut at a 15-degree angle in the base.On top of this, the track would shrink or expand based on the extreme temperature changes in my garage.This is one of those jobs where the only way you can learn is by actually doing.Once the adhesive has dried you can trim the edge.With Jeff content again, he resumed the tedious job of taping the track.Whatever you use, apply with a putty knife, sand using 100 or 120 grit paper on a sanding block, reapply as necessary.Oh, I still play with big cars once in a while.
We use a 20-amp Tenma brand power supply bought from MCM Electronics ( m for about 80 (on sale).
The proper tools can make any project easier. .
Buy those that are made for smooth surfaces get several; you cant reuse them.
Dont try to hurry things up during this stage; just be patient do a good job.
Its a pretty slow, tedious process, but it gives great results.(Jeff) Van Scoter email: - (OWH Webmeister note: Thank you again Larry Jeff!The control panels were placed where we thought they should go (consider driver visibility here we began wiring by installing the tap screws on the left side of the slots only, running wires from them to the negative (-) terminal strip.Fold some sandpaper once or twice sand the slots lightly, too.I made up a simple dispenser for the tape out of scrap pieces of MDF.A terminal strip was attached to the table frame in a central location, the power supply was connected to it with double 12-gauge stereo wire (zipcord).Some people prefer no scenery at all, or only a very abbreviated representation of scenery; others may prefer highly realistic terrain, trees, people, buildings cars.HO, N, O/O27, G, starter Sets, Rockets, cars, Airplanes, Boats, building Supplies: Tools: Toys: Other Hobbies: Metal, Balsa Wood Rotary, Airbrush Games, Kites Pinewood Derby, Puzzles.Brake wires were run next, from the negative (-) terminal strip to the red posts on all panels, finally the return wires were run from the positive terminal strip to the fuse holders on each panel.For these folks, I recommend utilizing the resources of model railroading.As long as the crash walls keep the cars off the floor, everything else about them is optional, really.
Categories, shopping Categories: HO Slot Cars: 1/32 Slot Cars: 1/24 Slot Cars: Plastic Models: Race Sets, Cars, race Sets, Cars, starter Sets, Cars, cars, Airplanes, Boats, wood Models: Model Railroading: Model Rockets: Radio Control: Ships, Accessories.